Filter
Top Products
24
PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walking belt is off-center, first remove the
k
ey and UNPLUG THE POWER CORD. If the
walking belt has shifted to the left, use the hex
k
ey to turn the left idler roller bolt clockwise 1/2 of a
turn; if the walking belt has shifted to the right,
turn the idler roller bolt counterclockwise 1/2 of a
turn. Be careful not to overtighten the walking belt.
Then, plug in the power cord, insert the key, and
run the treadmill for a few minutes. Repeat until the
walking belt is centered.
b. If the walking belt slips when walked on, first re-
move the key and UNPLUG THE POWER CORD.
Using the hex key, turn both idler roller bolts clock-
wise, 1/4 of a turn. When the walking belt is cor-
rectly tightened, you should be able to lift each
edge of the walking belt 2 to 3 in. (5 to 7 cm) off
the walking platform. Be careful to keep the walk-
ing belt centered. Then, plug in the power cord, in-
sert the key, and carefully walk on the treadmill for
a few minutes. Repeat until the walking belt is
properly tightened.
PROBLEM: The crosswalk arms squeak during use
SOLUTION: a. (Note: Correcting this problem re-
quires a small amount of white ma-
rine grease, available at hardware
stores.) Remove the Resistance
Knob (88) from the resistance as-
sembly. Remove the resistance as-
sembly from the Left Upright (77) or
the Right Upright (92).
Apply a small amount of grease
around the Resistance Cone (85).
Insert the resistance assembly into
the Left Upright (77) or the Right
Upright (92). Then, tighten the
Resistance Knob (88) onto the re-
sistance assembly.
a
b
88
92
85
77
Resistance
Assembly
a