Filter
Top Products
12
15. Remove the Resistance Knob (88) from a resis-
tance assembly. Make sure that the 3/8" x 4
3/4" Bolt (90) stays inside the resistance as-
sembly and that the resistance assembly
d
oes not come apart. Note: See the lower
drawing to reassemble the resistance assembly,
if necessary.
A
pply a small amount of the included grease
around the Resistance Cone (85). Insert the
Resistance Cone into the Upright Insert (84) in
the Left Upright (77), with the two large holes on
top as shown. Then, tighten the Resistance
Knob (88) onto the 3/8" x 4 3/4" Bolt (90).
Attach the other resistance assembly to the
Right Upright (92) in the same way.
88
Large
Holes
90
88
8
4
92
Large
Holes
8
5
90
77
16. Insert the end of a Crosswalk Arm (82) into the
hole in the top of a resistance assembly. Make
sure that the bend in the Crosswalk Arm is
positioned as shown.
Tighten a #8 x 3/4" Screw (1) into the resistance
assembly and Crosswalk Arm (82) from the di-
rection shown. Press a Small Cap (89) into the
hole for the Screw.
Attach the other Crosswalk Arm (82) in the
same way.
82
1
Hole
89
1
82
89
16
Bend
Resistance
Assembly
Bend
R
esistance
Assembly
15
85
84
Grease