Filter
Top Products
7
5. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet
from damage, place a mat under the treadmill.
4. With the help of a second person, carefully tip the
Uprights (82) down as shown.
Make sure that the
Extension Legs (103) remain in the Uprights.
Tighten a Handrail Bolt (78) with a Handrail Washer (36)
into each Extension Leg (103) and Handrail (85). Note: If
it is difficult to thread the Handrail Bolts into the Hand-
rails, pull one of the Handrails to the side and thread a
Handrail Bolt into the bottom of the Handrail. Notice the
angle of the Bolt. When attaching the Handrails to the
Extension Legs, insert the Bolts and Washers at the ob-
served angle. It should be close to the same angle as
the Handrails (see the inset drawing).
Note: Refer to figure 4b. If it is difficult to align the hole in
a Handrail (85) with the hole in an Extension Leg (103),
it may be necessary to move the Handrail up or down or
have a second person stand on the treadmill and lift the
Handrail.
Next, attach each Extension Leg (103) with two Screws
(101) and a Base Pad (116) as shown in drawing 4.
Make sure that the Extension Legs are fully inserted into
the Uprights (82). It may be necessary to push down on
the Uprights as you tighten the Screws.
With the help of a second person, carefully tip the
Uprights (82) back to the upright position.
Note: One replacement Base Pad (116) and Spacer (not
shown) are included. If a Base Pad becomes worn and
needs to be replaced, use the replacement Base Pad. If
a Thick Base Pad (97) needs to be replaced, use the re-
placement Base Pad with the Spacer.
101
36
78
101
82
78
103
103
103
82
97
85
97
3
. Insert the upper end of a Handrail (85) into the right
U
pright (82) as shown.
N
ote: It will be necessary to
pivot the Handrail to the side and back repeatedly
(see arrow A) while pushing on the Handrail (see
arrow B) to insert it fully into the Upright. Next, pivot
the lower end of the Handrail down, push it toward the
right Upright, and then align it with the indicated hole.
Insert the other Handrail (85) into the left Upright (82) as
described above.
8
2
85
85
82
Hole
3
B
A
85
85
78
36
4b
4
116
116
97