Filter
Top Products
9
7. Have a second person hold the handrail assem-
bly near the Right Upright (77) and the Left
Upright (78). Connect the Wire Harness (87) to
the console wire. See the inset drawing. The
connectors should slide together easily and
snap into place. If they do not, turn one connec-
tor and try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Remove the wire tie from the Wire Harness (87).
Set the handrail assembly on the Uprights (77,
78). Be careful not to pinch the wires.
77
78
Console
Wire
Wire Tie
7
87
Console
Wire
Handrail
Assembly
87
6. Hold a Bolt Spacer (82) inside the lower end of
the Left Upright (78). Insert a 3/8" x 4" Bolt (4)
with a 3/8" Star Washer (8) into the Left Upright
and the Bolt Spacer. Repeat this step with a
s
econd Bolt Spacer (82), 3/8" x 4" Bolt (4),
and 3/8" Star Washer (8).
Hold the Left Upright Spacer (81) and the Left
U
pright (78) against the Base (84). Tighten the
3/8" x 4" Bolts (4) until the heads of the Bolts
touch the Left Upright; do not fully tighten the
Bolts yet.
Press a Base Cap (80) into the Base (84).
With the help of a second person, tip the tread-
mill so that the Base (84) is flat on the floor.
8
1
7
8
4
84
82
82
80
8
6