Filter
Top Products
11
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated #8 x 1/2" Screw (12) and
the Access Door (92) from the Console Back
(95).
2. Connect the wire on the receiver to the indicated
wire extending from the Console Back (95).
Hold the receiver so the antenna is oriented
as shown and is facing the Console Back.
Attach the receiver to the plastic posts on the
Access Door (92) with the two included small
screws.
3. Be careful not to pinch the wires. Reattach
the Access Door (92) with the #8 x 1/2" Screw
Screw (12). Discard the other wires included
with the receiver.
Receiver
92
Antenna
12
95
Wire
Small
Screws
11. Raise the Frame (52) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (49) so that the large
barrel and the Latch Knob (50) are in the posi-
tions shown.
Attach the upper end of the Storage Latch (49)
to the bracket on the Frame (52) with a 3/8" x 2"
Bolt (6) and a 3/8" Nut (7).
Attach the lower end of the Storage Latch (49) to
the Base (84) with a 3/8" x 1 3/4" Patch Bolt (2).
Note: It may be necessary to move the Frame
(52) back and forth to align the Storage Latch
with the Base.
Lower the Frame (52) (see HOW TO LOWER
THE TREADMILL FOR USE on page 21).
12. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex
keys is used to adjust the walking belt (see pages 23 and 24).
49
84
7
Large
Barrel
2
52
11
6
50