Filter
Top Products
8
5. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (52) so the treadmill is more stable; do
not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Attach a Wheel (85) to the Base (84) with a
3/8" x 2" Bolt (6) and a 3/8" Nut (7). Do not
overtighten the Nut; the Wheel must turn
freely.
5
6
52
7
84
85
4. Hold a Bolt Spacer (82) inside the lower end of
the Right Upright (77). Insert a 3/8" x 4" Bolt (4)
with a 3/8" Star Washer (8) into the Right
Upright and the Bolt Spacer. Repeat this step
with a second Bolt Spacer (82), 3/8" x 4" Bolt
(4), and 3/8" Star Washer (8).
Hold the Right Upright (77) against the Right
Upright Spacer (88). Be careful not to pinch
the Wire Harness (87). Tighten the 3/8" x 4"
Bolts (4) until the heads of the Bolts touch the
Right Upright; do not fully tighten the Bolts
yet.
Press a Base Cap (80) into the Base (84).
88
77
87
8
80
82
82
4
4
84
3. Identify the Right Upright (77) and the Right
U
pright Spacer (88), which are marked with
“Right” stickers. Insert the Wire Harness (87)
through the Right Upright Spacer as shown.
Then, set the Right Upright Spacer on the Base
(
84).
H
ave a second person hold the Right Upright
(77) near the Base (84). See the inset drawing.
Tie the wire tie in the Right Upright securely
around the end of the Wire Harness (87). Then,
pull the other end of the wire tie until the Wire
Harness is routed completely through the Right
Upright.
84
W
ire Tie
87
7
7
88
87
3
Wire
Tie
77
87
A
B