Filter
Top Products
Assembly
Assembly requires two people. Set the incline trainer in a cleared area and remove all packing materials. Do
not dispose of the packing materials until assembly is completed. Assembly requires the included allen
wrench and your own phillips screwdriver .
Note: The underside of the incline trainer walking belt is coated with high-performance lubricant. During shipping,
a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect trainer performance. If there is lubricant on top of the walking belt, simply wipe
off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Refer to the drawings below to identify the parts used in assembly.
6
2. Attach the Console (99) to the Handrail (27) with the four
Small Screws (6). Make sure that the Handrail Wire
Harness (not shown) is not pinched between the
Console and the Handrail.
6
99
6
6
27
2
1. Set the Console (99) and the Handrail (27) on the floor.
Locate the Handrail Wire Harness (30) in the Handrail
(27). While a second person holds the Console (99), con-
nect the 8-pin wire of the Handrail Wire Harness to the
HD2 connector on the back of the Console. Next, connect
the 4-pin wire to the IFIT2 connector, and the 3-pin wire
to the HD1 connector shown.
99
27
30
HD1
HD2
IFIT2
1
Small Screw (6)–4
Long Upright Bolt (54)–4
Handrail Star
Washer (26)–4
1” Upright Bolt (33)–4
Internal Star
Washer (32)–4
Handrail Bolt (25)–4