Filter
Top Products
12
The Distance/Time
display—When the
manual mode or an
iFIT.com program is se-
lected, this display will
show the distance you
have hiked and the elapsed time. The distance will
be shown for seven seconds and the time will be
shown for fourteen seconds, as shown by the indi-
cators around the display.
When a preset program is selected, the Distance/
Time display will show the distance you have hiked,
the time remaining in the program, and the time
remaining in the current segment of the program.
Pulse display—This
display will show your
heart rate when the op-
tional heart rate moni-
tor is worn. (For infor-
mation about the op-
tional heart rate monitor, see page 19.)
To reset the displays, press the Stop button, re-
move the key, and then re-insert the key.
When you are finished exercising, stop the
walking belt and remove the key.
Step onto the foot rails and press the Stop button.
Next, remove the key from the console and put it in
a secure place. Note: If the displays and indica-
tors on the console remain lit after the key is
removed, the console is in the “demo” mode.
Refer to page 19 and turn off the demo mode.
When you are finished using the trainer, move the
on/off switch near the power cord to the off position
and unplug the power cord.
HOW TO USE PRESET PROGRAMS
The console offers twelve preset programs. Each preset
program automatically controls the grade and speed of
the trainer to simulate a hiking trail as it guides you
through an effective workout. You can choose from four
beginner programs, four intermediate programs, and
four advanced programs.
Follow the steps below to use a preset program.
Insert the key fully into the console.
See GETTING STARTED on page 10.
Select the desired preset program.
When the key is inserted, the manual mode will be
selected. To select a preset program, press the
Select Program
button repeat-
edly. The
twelve trails
shown in the
trail display
represent the
twelve preset
programs. As
you press the
Select Program button repeatedly, indicators will
light in the trail display to show which trail you
have selected.
When a preset program is selected, the matrix will
show the grade settings for the program. (For the
longest programs, the matrix will not show all of
the grade settings at once.) In addition, the Speed
display will show the maximum speed setting for
the program and the Vertical Feet/Cals./Grade
display will show the maximum grade setting for
the program.
2
1
6
Trail Display