Filter
Top Products
9
25
25
96
2
7. Hold the halves of the Upper Handlebar Cover (25)
around the tube on the front of the Upright (2); be
careful not to damage the Wires (not shown).
Attach the Upper Handlebar Cover with an M4 x
12mm Round Head Screw (96).
7
8. Apply a liberal amount of grease to the long side of
each M8 x 79mm Bolt Set (65).
Identify the Left Pedal (10), which has a notch near
the right side. Place the Left Pedal on the Left Pedal
Leg (4). Have a second person hold the bracket on
the left Upper Body Leg (31) inside of the bracket on
the Left Pedal Leg, and hold a Wheel (28) inside of
the bracket on the left Upper Body Leg.
Align the indicated holes, and attach the Left Pedal
(10), the left Upper Body Leg (31), and the Wheel (28)
to the Left Pedal Leg (4) with an M8 x 79mm Bolt Set
(65). Attach the rear of the Left Pedal to the Left Pedal
Leg with two M8 x 54mm Button Screws (83) and two
M8 Split Washers (130)..
Repeat this step on the right side of the elliptical exer-
ciser.
See step 4. Tighten the two M10 x 108mm Button
Screws (70).
4
10
5
83
130
65
28
Notch
8
65
31
Holes
Grease