Filter
Top Products
8
7. Lubricate the M10 x 180mm Bolt (28). Attach the
Backrest (12) to the Bench Frame (5) with the
Bolt, two M10 Washers (6), and a M10 Nylon
Locknut (11).
Secure the Backrest (12) to the Bench Frame (5)
by inserting the Locking Pin (27) through one of
the three sets of holes in the adjustment tubes
and the tube (not shown) on the Bench Frame.
Make sure the Locking Pin (27) is completely
inserted through both adjustment tubes.
Tighten the M6 x 38mm Bolts used in step 6.
8. Attach the Seat (17) to the Bench Frame (5) with
four M6 x 16mm Bolts (26)
9. Tap two 50mm Round Inner Caps (25) into the
ends of the Leg Lever (7). Insert a 25mm Round
Inner Cap (36) into the end of the weight tube on
the Leg Lever. Place a 25mm Angle Cap (35) on
the other end of the weight tube.
Attach the Leg Lever (7) to the Front Leg (3) with
a M10 x 70mm Bolt (32) and a M10 Nylon
Locknut (11).
11
6
5
Adjustment
Tubes
12
27
7
5
17
26
26
11
25
Weight Tube
7
36
25
35
3
32
8
9
28
6
10. Place a 19mm Round Inner Cap (33) into each
end of the Long Pad Tube (41). Insert the Long
Pad Tube through the holes in the Front Leg (3).
Slide a Leg Pad (22) onto each side of the Long
Pad Tube.
22
33
22
3
41
10