Filter
Top Products
9
6. Place the treadmill in the storage position (see HOW TO
FOLD AND MOVE THE TREADMILL on page 26).
Next, place the cylinder end of the Shock (92) near the
bracket on the base of the Uprights (84).
See the two small inset drawings. Using your fingernail
or the end of a screwdriver, press on the end of the
Shock Pin (25) to loosen it from the Shock (92). Next, ro-
tate the Shock Pin and pull it out of the Shock.
Be care-
ful to avoid losing the Shock Pin.
See drawing 5a. Press the cylinder end of the Shock (92)
onto the ball on the bracket. Next, insert the end of the
Shock Pin (25) through two of the small holes in the end
of the Shock. Then, rotate the Shock Pin until it clips onto
the Shock.
92
25
92
25
6
5a
84
Bracket
Cylinder
Bracket
25
25
7. Raise the Shock (92) to a vertical position. Remove the
Shock Pin (25) from the raised end of the Shock as de-
scribed in step 6. If necessary, rotate the Shock to align
the end of the Shock with the ball on the bracket on the
Frame (58).
Next, press the Incline increase and decrease buttons
until the ball on the bracket is aligned with end of the
Shock (92). Then, press the end of the Shock onto the
ball. Note: It may be necessary to press the end of the
Shock onto the ball while the Frame is moving.
See drawing 7a. Insert the Shock Pin (25) into the two in
-
dicated small holes in the end of the Shock (92). Then,
rotate the Shock Pin until it clips onto the Shock. Note:
Extra Shock Pins are included.
Press the Incline decrease button until the treadmill
is at the lowest incline level. Then, unplug the power
cord.
25
92
Holes
25
92
7
7a
58
Bracket
5
. Orient the Latch Housing (73) so the large hole is on the
indicated side. Attach the Latch Housing to the left
Upright (84) with two Latch Screws (3); start both Latch
Screws and then tighten them.
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Next, insert
the pin into the Latch Housing (73). Then, tighten the
knob back onto the pin.
Plug in the power cord as described on page 13, and
turn on the power as described on page 15. Note: The
treadmill may automatically rise to the maximum incline
level and then return to the minimum level.
3
Pin
Spring
Collar
Knob
73
5
84
Large
Hole