Filter
Top Products
S3.45 Assembly and Maintenance Guide
page 23
1 2 3 4 5 6
F. Attach two Floating Pulley Plates to one
4½-inch pulley using
one 2-inch bolt
two washers
one locknut
Finger tighten.
G. Loop the Cable from the Top Frame around the
pulley.
H. Loop the Cable from the Main Base around one
4½-inch pulley and attach it to the remaining holes
in the Floating Pulley Plates using
one 2-inch bolt
two washers
one locknut
I. Wrench tighten all bolts from this step.
J. Ensure the Weight Pin is in place. Hold the
threaded end of the Cable in place with pliers, and
tighten the locknut until there is no slack in the
Cable. If the weights lift, you have over-tightened.
Step 12. Feed Upper Leg Curl Cable, Continued
F
H
1 - 4½" pulley
1 - 2" bolt
2 - washers
1 - locknut
1 - 4½" pulley
1 - 2" bolt
2 - washers
1 - locknut
J
G
Cable from the Top
Frame