Filter
Top Products
Experience Strength™ C-Line Owner’s Manual: Daily Inspection
7
Daily Inspection
You will need to perform the following tasks each day to maintain the
equipment and keep it operating smoothly:
• Clean any upholstery on the equipment.
• Inspect pads for wear.
• Clean and inspect equipment frames.
• Inspect cables and end connections for wear.
• Check warning and instructional labels.
Perform the tasks that are appropriate for the equipment you are
maintaining, and skip the tasks that do not apply.
Clean Upholstery
To remove surface dirt and perspiration, clean upholstery daily with a mild
soap and water solution in a spray bottle. Spray upholstered surfaces lightly
and wipe them dry with a clean cloth.
Important: To clean the upholstery, do not use cleaning products that have any of
these ingredients: solvents, alcohol, ammonia, or petroleum. Use a mild
detergent-based cleaner instead.
Inspect Pads for Wear
Inspect pads for cracks in the upholstery, loose staples, and loose mounting
bolts. Replace pads as needed (refer to
Obtaining Service
to purchase new
pads).
Important: Do not reupholster pads or use pads not approved by Precor.
Clean and Inspect Frames
To remove grease and dirt, clean frames daily with a mild soap and water
solution in a spray bottle. Wipe the equipment down with a damp cloth and
dry completely. Be sure to wipe down both painted parts and chrome parts.
To restore and maintain the luster of chrome parts, use a commercial
chrome cleaner.
As you clean, inspect the frames for cracks, rust, or other damage. Make
sure welds are solid and fasteners are properly secured.