Filter
Top Products
Cardio Theater Integrated Bracket Assembly Instructions
page 8
6. Feed the coaxial/power cable and its connectors
through the upright support.
Ask your assistant to hold the bracket assembly
close while you insert the cable and its
connectors into the upper hole on the upright
support. Slide the cable down until you can
access the connectors through the lower hole.
Note: You may need to move the ribbon cable
inside the upright support to gain clear access.
7. Pull the cable and its connectors out of the
lower hole. If needed, use a needle-nose pliers
to grasp the cable.
Note: While you pull about 3 feet (1 meter) of
cable out of the lower hole ask your assistant to
align the bracket assembly with the mounting
fasteners on the upright support. Make sure the
bracket assembly slides into place along the
outside of the upright support.
8. Attach the bracket assembly and replace the
fasteners.
Ask your assistant to continue holding the
bracket assembly, while you replace the three
fasteners removed in step 4. Securely tighten
all three screws using a ⁵⁄₃₂-inch hex key.
Install the Bracket Assembly
6
7
8
Bracket assembly
Rubber boot
Coaxial/power cable
(with coaxial and power connectors)
Display console
Upright support