Precor 9.23 Treadmill User Manual


 
Owner’s Manual: Maintenance 42
Cleaning the Equipment
Most of the working mechanisms are protected inside the
hood and base of the treadmill. However, for efficient
operation, the treadmill relies on low friction. To keep the
friction low, the unit’s running belt, staging platforms, and
internal mechanisms must be as clean as possible.
Precor recommends the treadmill be cleaned before and
after each workout. Use mild soap and water to dampen a
soft cloth and wipe all exposed surfaces. This helps
remove any dust or dirt.
CAUTION: Do not use any acidic cleaners. Doing so will
weaken the paint or powder coatings and void the
Precor Limited Warranty. Never pour water or spray
liquids on any part of the treadmill. Allow the treadmill to
dry completely before using.
Frequently vacuum the floor underneath the unit to prevent
the accumulation of dust and dirt, which can affect the
smooth operation of the unit. Use a soft nylon scrub brush
to clean the running belt.
Storing the Chest Strap
Store the chest strap in a place where it remains free of
dust and dirt such as, in a closet or drawer. Be sure to
protect the chest strap from extremes in temperature. Do
not store it in a place that may be exposed to temperatures
below 32° F (0° C).
To clean the chest strap, use a sponge or soft cloth
dampened in mild soap and water. Dry the surface
thoroughly with a clean towel.
92x_Owners Manual.book Page 42 Tuesday, April 22, 2008 8:18 AM