Filter
Top Products
Page 26
Maintenance and Troubleshooting
The 718e climber requires very little maintenance. The only maintenance you
need to do periodically is to clean the climber. You will also need to change the
batteries when they wear down. Instructions for these procedures are provided
in this section.
If you encounter problems with the climber, refer to
Troubleshooting Tips
in this
section for help.
Cleaning the Climber
Clean the 718e climber periodically with mild solution of soap and water or a
general household cleaner. Wipe the surface of the electronic console with a
moist sponge or cloth. Dry with a clean towel. Never pour liquids on the 718e
electronic console.
Changing the Batteries
The electronic console comes with two “AA” alkaline batteries installed. When
your console no longer shows a digital readout or the count becomes erratic,
you need to change the batteries.
Note: Occasionally, the batteries can become dislodged, so you need to
reposition the batteries in the drawer, but not necessarily replace them with new
batteries.
1. Find the drawer on the side of the electronic console and press in lightly to
open it.
2. Use your fingers to slide the drawer out and expose the battery case.
Remove the old batteries and replace them with two new “AA” alkaline
batteries. The displays light up and the console beeps.
Note: Align the batteries to the proper polarity (+ and - indicators are inside
the battery case).
3. Close the battery drawer by pushing it gently into the electronic console.
4. Press START/STOP to activate the timer (TIME display).
Note: Press RESET to “reset” the displays to zero.
CAUTION: Abrasive cleaners
or polishes will damage the
surface finish.