Filter
Top Products
Page 12
Diagram 12
Install electronic console
Phillips-head screws
Electronic console
8. Install Electronic Console. (Diagram 12) To attach the electronic console
display to the handrail console, take the following steps:
a. Plug the slotted reed switch cable connector into its receptacle on the
underside of the electronic console display.
b. Place the electronic console display on the handrail console while you
gently feed any excess cable back through the hole in the handrail
console.
c. Align the holes and insert two phillips-head screws (F) on the
underside of the handrail console.
d. Tighten the screws using your phillips-head screwdriver.
Handrail console
CAUTION: Make sure you do
not crimp the reed switch
cable when you tighten the
base column support onto the
upright support because you
could void the manufacturer’s
limited warranty.
Diagram 13
Install the batteries
USA
R
9. Insert Batteries. (Diagram 13) Find the drawer on the side of the electronic
console and press in lightly to open it. Pull the drawer out with your
fingers. Take the following steps to insert the batteries:
a. Slide the drawer out to expose the battery case. Place the two “AA”
alkaline batteries (found in the hardware kit) into the case. Align the
batteries to the proper polarity (+ and - indicators are inside the
battery case). The entire display lights and the console beeps.
b. Close the battery drawer by pushing it gently into the electronic
console.
c. Press START/STOP to activate the timer (TIME display). Press RESET
to “reset” the displays to zero. For more information, refer to the
section titled,
Understanding the Electronic Console.
Battery drawer
AA battery case