Filter
Top Products
Page 15
1
3
2
4
5
Diagram 18
Measure the distance of the
resistance cylinders from the
mounts
1/4" to 1/2"
Adjustment knob
Resistance cylinder mount
g. Press the right footpad down onto the rear crossbar. Let the left stair
arm move up into its highest position (away from the rear crossbar).
Check the distance between the top of the resistance cylinder on the
left stair arm and the upper axle. It should be between 1/4 to 1/2
inches (.1 to .2 centimeters). See Diagram 18. If the distance is
correct, you have installed the rope properly. If the adjustment knob
touches the resistance cylinder mount, you will need to replace the
rope and readjust the length.
Note: To obtain a new rope call your local Precor dealer at 1-800-4-
PRECOR.
Every time you use your climber, make sure that all frame-to-frame and frame-
to-base bolts are still tight. If there is any movement, firmly re-tighten all bolts.