Filter
Top Products
software also allows you to make graphical comparisons with previous results. The Polar Fitness Test
results are downloaded automatically to the software when you download exercises using the Transfer
Data option.
10. USING A NEW ACCESSORY
Teaching
Your CS600 cycling computer has been synchronized, or “taught” to work together with the Polar
WearLink W.I.N.D. transmitter and to measure heart rate, speed and distance. In other words, your
cycling computer receives signals from your transmitter and speed sensor only, and enables
disturbance-free exercise in a group.
If you purchase a new transmitter, speed, cadence* or power* sensor as a separate accessory, they
have to be introduced to the cycling computer. This is called teaching and takes only a few seconds.
To prevent interference during a cycling event, make sure you perform the teaching process prior to the
event.
Teach New Transmitter
Wear the transmitter and make sure that you are not near (40 m/131 ft) other Polar WearLink W.I.N.D.
transmitters. In time mode, press OK. The cycling computer starts searching for the transmitter signal.
Once the new transmitter is identified, New WearLink found, Teach new WearLink? is displayed.
• Select Yes to confirm teaching. Completed! and Exercise displays updated are displayed. Start exercise
recording by pressing OK.
• Select No to cancel teaching.
Teach New Speed Sensor
Make sure that there are no other speed sensors or cycling computers nearby (40 m/131 ft). The
teaching procedure only takes a few seconds.
You can teach one Speed sensor for each bike setting.
Select Settings > Bike > Bike1 > Speed > On/Off
Select > On > Teach new sensor? is displayed
• Select Yes to confirm teaching > Start test drive is displayed. Rotate the wheel a few times to
activate the sensor. A flashing red light indicates that the sensor is activated.
Completed! and Exercise displays updated are displayed. The cycling computer is now ready to receive
speed and distance data.
• Select No to cancel teaching and the already earlier taught speed sensor is taken into use.
If you haven’t taught speed sensor to recognize a certain bike before, speed information will not be shown.
Select > Off and the display returns to the previous menu display.
To return to time mode, press and hold the BACK button.
Once the speed sensor is taught to recognize the cycling computer, it will do so even if the sensor has been
turned off. When the speed sensor is turned back on Teach new sensor? is displayed. Select No and
Exercise displays updated appears. If Yes is selected, the monitor goes into teaching mode.
Teach New Cadence Sensor*
Select Settings > Bike > Bike1 > Cadence > On/Off
Polar CS600 User Manual 43