Filter
Top Products
FIGURE 11
T
RIGHT
STEP 11:
¯
Slide one BEARING HOUSING (1), one 2" SHAFT COLLAR (23), and one 2-1/2" OD RUBBER BUMPER (29) over
SLEEVE ASSEMBLY (4) as shown in FIGURE 11.
¯
Using a 1/4" Allen wren,:h, SECURELY tighten each set screw on the 2" SHAFT COLLARS (23). See FIGURE 11.
~
,DETAIL 12
..__
~. ]
FIGURE 12
~
STEP 12:
¯ Slide one BEARING HOUSING (1) & SLEEVE ASSEMBLY (4) over each end of the SMITH BAR (7) as shown in FIGLrI~E
12.
¯ Using a 5/16" Allen v,Tc~ach, SECURELY tighten the SLEEVE ASSEMBLIES (4) to the SMITH B~LR (7) with ~-o 5/8 X
4" SHOULDER BOLTIg (19). See DETAIL 12.
[ 1/2 I
1/2
I
1/2
I
1/2 I
1/2 I
1/2 I
6
4
[ I ! _1_
3
[ I I I