Filter
Top Products
'IMPORTANT
NOTESI
Please note:
*
Thank you for purchasing the ParaBody LAT MACHINE. Please read these
instructions thoroughly and keep them for future reference. This product must be assembled
on a flat, level surface to assure its proper function.
*This product must be assembled on a flat, level surface to assure its proper function.
DO
NOT
securely tighten any frame connections until the entire frame has been assembled, unless
otherwise stated.
ITools Required for Assembly I
* Rubber mallet or hammer
*
3/4"
wrench
*9/16" wrench
* Ratchet with 3/4" and 9/16" sockets
*5/32" Allen wrench
* Adjustable wrench
*Tape measure
1
B_ol_t
_L_en~gt,-h_R_u_l_er
i
NOTE: BOLT
LENGTH
IS MEASURED
FROM
THE
UNDERSIDE
OF
THE HEAD
OF
THE
BOLT.
I-----BOLT
LENGTH
~
BOLT
LENGTH
RULER:
I 1/2 I 1/2 I 1/2 I 1/2 I 1/2 I 1/2 I
O'L.-
-L--1~--1..t
--J--.L-I
.-.L---lT~----l-I--I-_3l..-'
--I--1..I--1..--I-t
-.L---lI----l.--l-T
--I--L-I
--4----11
3
MAINTENANCE I
Please note:
*
We
recommend cleaning your product (pads and·frame) on a regular basis, using warm soapy
water. Touch-up paint can be purchased from your ParaBody customer service representative
at (800) 328-9714.
* Inspect equipment daily. Tighten all loose connections are replace worn parts immediately.
Failure to do so may result in serious injury
* Lubricate guide rods with a teflon based (or equivalent) lubricant on a regular basis
* PLEASE RECORD THE INFORMATION REQUESTED BELOW. IN
THE
EVENT
YOU
MAY
NEED SERVICE YOU
WILL
BE ASKED
FOR
THIS INFORMATION.
REMEMBER
TO
FILL
OUT YOUR WARRANTY REGISTRATION CARD AND
MAIL
BACK
MODEL # _
SERIAL # _
DATE
OF
PURCHASE: _
DEALERS NAME: _
DEALERS PHONE
# _
Thank
you for purchasing the
ParaBody
827 LAT MACHINE.
16