Filter
Top Products
FIGURE 9
bolts.
~TANT: Cable must run over the top of
STEP 9
Install the NEW 110-3/4" CABLE ASSY (16) using the following steps:
¯ Route the CABLE (16) through the TOP BOOM as shown in FIGURE 9. The pulleys in TOP BOOM may need to be temporarily
removed to perform this step. (Note: Make sure the CABLE is running OVER the BOLTS connecting the FRONT UPRIGHT
to the TOP BOOM. These may also have to be removed to perform this step.)
¯
Route the CABLE (16) around the PULLEY BLOCK as shown in FIGURE
¯ Route the CABLE (16) back over one pulley in the TOP BOOM, down through the PULLEY BRACKET (2) and over the second
pulley in the TOP BOOM.
¯
Screw the threaded end of CABLE (16) into the HEAD PLATE
ASSEMBLY.
STEP 10
¯
Loop CABLE (16) around one 3-1/2" PULLEY (5) in the PULLEY
BRACKET (2) using one 3/8 X 1-3/4" BOLT (13) and one
LOCKNUT (11) as shown in FIGURE 10.