Filter
Top Products
FIGURE 8
REMOVE
STEP 8
Remove the existing LAT CABLE using the following steps:
¯ Disconnect LAT BAR from TOP BOOM.
¯ Unscrew the threaded end of CABLE from the HEAD PLATE ASSEMBLY.
¯ Route the LAT CABLE around the PULLEY BLOCK as shown in FIGURE 8.
¯ Route the LAT CABLE around the TOP BOOM as shown in FIGURE 8.
¯ The pulleys in TOP BOOM may need to be temporarily removed to remove CABLE.
0
1 2 ] I I I
6
1/2
t
l/Z
I
5 6