Filter
Top Products
14
EN
• Light Mode ON or OFF - see "Activating the Backlight" section.
To set these features:
1. Press MODE to navigate to the Real-Time Clock Mode.
SIGNAL SEARCH
To force a signal search:
1. Press MODE to navigate to the SMART TRAINING PROGRAM
or Stopwatch Mode.
2. Press and hold MODE for 2 seconds. The signal-searching
icon
with the outside flashing will appear to confirm a signal
search is taking place. Whenever the watch is searching for
the chest belt signal make sure that the chest belt is no further
than 10 cm (4 inches) from the watch.
The signal search will take approximately 10 seconds. If after
10 seconds the heart icon is not flashing, then your signal search
has been unsuccessful and you need to force another signal search.
See the table in the "Transmission Signal" section for more signal
status information.
SETTING THE KEYPAD TONE / LIGHT MODE
You can set the watch to have the:
• Keypad "Beep" tone ON or OFF.
SE212 English R7 OP_OK.p65 2006.1.6, 1:53 AM14