Filter
Top Products
13
EN
3. Interference from another person's heart rate monitor - their
heart rate readings appear on your watch, or the heart rate
monitor shows "0":
• Press the chest belt button to get the watch to receive your
chest belt signal. Do not press and hold the chest belt button,
as it will change the transmission signal from digital to
analog.
•Take the chest belt off for 12 seconds to automatically
change your User ID. (The watch has 4 User ID's. When
the watch receives the chest belt signal it will tell you which
User ID it has selected. Only products with a digital coding
system have User ID capability.)
4. The signal is jammed - the heart rate reading on your watch is
flashing:
• There is too much interference in the environment for your
heart rate monitor to function. Move to an area where the
heart rate reading stops flashing.
Signal interference in the environment can be due to
electromagnetic disturbances. These may occur near high voltage
power lines, traffic lights, overhead lines of electric railways, electric
bus lines or trams, televisions, car motors, bike computers, some
motor driven exercise equipment, cellular phones or when you
walk through electric security gates. Under interference, the heart
rate reading may become unstable and inaccurate.
WARNING
2. The gym equipment does not seem to work with your chest
belt and the
digital icon
is displayed:
• Most gym equipment is compatible with the analog system
. Press and hold the chest belt button for more than 4
seconds to change from digital to analog. Then force a signal
search (see “Signal Search” section)
SE212 English R7 OP_OK.p65 2006.1.6, 1:53 AM13