Filter
Top Products
ASSEMBLY
A
ssembly requires two persons.
S
et the treadmill in a cleared area and remove all packing materials.
D
o not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver ,
standard screwdriver , and wire cutters . For help identifying the assembly hard-
ware, see the hardware drawings below.
Console Bolt (72)–2
3
Handrail Bolt (66)–4
Star Washer (67)–12
Cover Screw (90)–2
Short Console
Bolt (112)–2
1” Tek Screw (82)
Pulse Bar Bolt (13)–4
Base Plate Bolt (125)–3
128
20
130
130
81
81
82
82
37
37
1
128
1. With the help of a second person, tip the Uprights (20)
down to the position shown. Next, slide the treadmill out
of the box.
Attach the four Base Pads (81) and two Plastic Spacers
(37) to the bottom of the Uprights (20) with the four 1”
Tek Screws (82) in the locations shown.
Thread the two Leveling Feet (130) into the bottom of the
Uprights (20).
Insert the three Cage Nuts (128) into the three indicated
holes in the treadmill. To insert each Cage Nut, first hook
one side of the Cage Nut into a hole. Then use a stan-
dard screwdriver to press the other side of the Cage Nut
into the hole, as shown
82
6