Filter
Top Products
16
38. Attach the Seat (14) to the Seat Frame (9) with
two M6 x 50mm Button Head Screws (91) and an
M6 x 63mm Button Head Screw (92).
40. Attach a Leg Developer Strap (43) to the Leg
Developer (10) with an M8 x 12.5mm Button
Head Shoulder Screw (83).
Attach the other Leg Developer Strap (43) in
the same manner.
41. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on page 21 of this manual for proper cable routing. If there is any slack in the
cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING AND
MAINTENANCE on page 20.
39. Attach the Right Leg Pad (19) to the Leg
Developer Plate (18) with two M8 x 19mm Button
Head Bolts (88).
Attach the Left Leg Pad (20) in the same man-
ner.
38
14
91
9
92
91
39
40
19
20
18
83
43
10
88