Filter
Top Products
15
35. Attach the Seat Upright (8) to the Seat Base (7)
with two M10 x 68mm Carriage Bolts (73) and
two M10 Nylon Locknuts (101).
37. Attach the Leg Developer Plate (18) to the Leg
Developer (10) with two M10 x 82mm Carriage
Bolts (82) and two M10 Nylon Locknuts (101).
Lubricate the 1/2” x 76mm Button Head Bolt (84)
with grease. Attach the Leg Developer (10) to the
Seat Frame (9) with the Bolt and a 1/2” Nylon
Locknut (100). Do not overtighten the Locknut;
the Leg Developer must be able to pivot easily.
36. Have one person hold the tabs on the Seat
Frame Bushing (44) inside of the holes in the
Seat Frame (9). Pull the Seat Knob (48) out as
far as it will go and slide the Seat Frame into the
Seat Upright (8). Press the Seat Frame Bushing
into the top of the Seat Upright so that the tabs
snap into the slots in the Upright. Engage the
Knob into the Seat Frame. Be careful not to
pinch your fingers as you complete this step.
35
7
73
8
101
101
36
48
44
Tab
Hole
Slots
8
9
37
100
101
84
Lubricate
9
10
18
82