Filter
Top Products
27
TROUBLESHOOTING
Most incline trainer problems can be solved by following the steps below. Find the symptom that applies,
a
nd follow the steps listed. If further assistance is needed, please see the front cover of this manual.
PROBLEM: The power does not turn on
S
OLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 14). Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 14. IMPORTANT: The incline trainer is
not compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
c. Check the power switch located on the incline
trainer frame near the power cord. If the switch pro-
trudes as shown, the switch has tripped. To reset
the switch, wait for five minutes and then press the
switch back in.
PROBLEM: The power turns off during use
SOLUTION: a. Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes
and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the incline trainer still will not run, please see the front cover of this manual.
PROBLEM: The console displays remain lit when you remove the key from the console
SOLUTION: a. The console features a display demo mode, designed to be used if the incline trainer is displayed
in a store. If the screen remains lit when you remove the key, the demo mode is turned on. To
turn off the demo mode, see step 4 on page 24.
PROBLEM: The console does not display speed and distance correctly
SOLUTION: a. Remove the key from the console and UNPLUG THE
POWER CORD. Next, remove the three indicated #8
x 1/2" Cover Screws (18). Lift off the Left Roller Cover
(38).
Tripped Reset
c
18
18
a
38