Filter
Top Products
23
HOW TO USE THE MAINTENANCE MODE
The console features a maintenance mode that allows
y
ou to calibrate the incline and speed of the treadmill,
restore factory defaults, calibrate the screen, update
t
he console firmware, and view technical information.
1. Select the settings mode.
See step 1 on page 21.
2. Select the maintenance mode.
Press the Maintenance
button in the lower right
corner of the screen to
enter the maintenance
mode.
3. Calibrate the incline system of the treadmill.
Press the Calibrate Incline button. The treadmill
will automatically rise to the maximum incline level,
lower to the minimum incline level and then return
to the starting position. This will recalibrate the in-
cline system. Press the Begin button to calibrate
the incline or the Cancel button to return to the
maintenance mode. When the incline system is
calibrated, press the Back button.
IMPORTANT: Keep pets, feet, and other objects
away from the treadmill while the incline is cali-
brating. In an emergency, pull the key from the
console to stop the incline calibration.
4. Restore factory defaults.
If necessary, press the Restore Defaults button to
reset the firmware to the original factory firmware.
This will erase all firmware updates that you have
downloaded. Press the Begin button to restore the
default firmware or the Cancel button to return to
the maintenance mode.
When the restoration is complete, the words
PLEASE CYCLE POWER will appear in the grey
box. Switch the reset/off circuit breaker to the off
position. Wait for several seconds, and then switch
the circuit breaker to the reset position. It may take
a minute for the console to be ready for use.
5. Calibrate the screen.
If the screen is not properly calibrated, it will be dif-
f
icult to press the buttons on the screen. To cali-
brate the screen, press the Calibrate Screen button
a
nd then press the Begin button. Press the Cancel
button to return to the maintenance mode.
Using a pencil eraser or other small object, press
the center of the small target on the screen. Then,
press the next two targets.
6. Calibrate the speed of the treadmill.
Calibrate the speed of the treadmill only if in-
structed to do so by an authorized service repre-
sentative.
Note: The Calibrate Speed button may not be en-
abled on your treadmill.
7. Update the console firmware.
For the best results, regularly check for
firmware updates.
Press the Firmware Update button. Press the
Begin button to check for updates or the Cancel
button to return to the maintenance mode.
A status bar will appear in the grey box on your
screen. When the update is complete, the words
PLEASE CYCLE POWER will appear in the grey
box. Switch the reset/off circuit breaker to the off
position. Wait for several seconds, and then switch
the circuit breaker to the reset position. It may take
a minute for the console to be ready for use.
8. View technical information.
Press the Technical Info button to view the total
number of hours that the treadmill has been used
and the total number of miles that the walking belt
has moved. When you are done viewing the infor-
mation, press the Finish button.
9. Exit the maintenance mode.
To exit the maintenance mode, press the Back but-
ton repeatedly.