Filter
Top Products
7. Set the console assembly on the Left and Right
Handrails (101, 102) and the Uprights (43). Be
careful not to pinch any wires.
T
ighten two 1/4" x 1/2" Patch Bolts (28) with two
1/4" Star Washers (116) into the Handrails (101,
102) and the console assembly. Do not fully
tighten the Patch Bolts yet.
Attach the two Console Clamps (104) to the
console assembly with four #8 x 1" Screws
(115). Start all four Screws, and then tighten
all of them. Be careful not to overtighten the
Screws.
Tighten the two 1/4" x 1/2" Patch Bolts (28).
7
102
43
104
28
101
28
115
116
116
115
Console
Assembly
10
104
8. Orient the Latch Housing (89) so that the large
hole is on the side shown. Attach the Latch
Housing to the left Upright (43) with two #8 x
3/4" Screws (12). Do not overtighten the
Screws.
Locate the Latch Assembly (88). Remove the
knob from the pin; make sure that the collar and
the spring are on the pin. Then, insert the pin
into the Latch Housing (89), and tighten the
knob back onto the pin.
12
Spring
Knob
89
8
43
Collar
Large
Hole
Pin
88