Filter
Top Products
13
15. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 26 and 27).
14. Raise the Frame (55) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (51) so that the large
barrel and the latch knob are oriented as shown.
Remove the tie from the upper end of the
Storage Latch (51). Attach the upper end of the
Storage Latch to the Frame (55) with a 3/8" x 1
3/4" Patch Bolt (6).
Remove the tie from the lower end of the
Storage Latch (51). Keep the holes in the latch
cap aligned with the holes in the Storage Latch.
Make sure to keep the latch cap inside the
Storage Latch. Attach the Storage Latch to the
Base (94) with a 3/8" x 2" Bolt (3) and a 3/8" Nut
(10). Note: It may be necessary to move the
Frame (55) back and forth to align the Storage
Latch with the Base.
Lower the Frame (55) (see HOW TO LOWER
THE TREADMILL FOR USE on page 24).
51
94
10
Large
Barrel
3
6
55
13
Latch Knob
Latch
Cap
13. IMPORTANT: See page 14 and plug in the
power cord. Next, see page 16 and turn on
the power.
T
hen, press the Incline increase button
once.
When the frame stops moving, remove the
k
ey from the console and unplug the power
cord.
15
IMPORTANT:
Make sure to follow all
instructions in this step.