Filter
Top Products
11
9. With the help of a second person, hold the sides
of the console assembly and place the console
assembly near the Right Upright (83) and the
Left Upright (not shown). Do not lift the con-
s
ole assembly by the Right Handrail (79) or
the Left Handrail (not shown).
Connect the Upright Wire (85) to the console
w
ire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the
Upright Wire.
Console
A
ssembly
9
Console
Wire
Wire
Tie
85
79
83
85
Console
Wire
10. Slide a Handrail Cover (77) onto the lower end
of each Handrail (78, 79).
Set the console assembly on the Left and Right
Uprights (82, 83). At the same time, insert the
lower end of the Handrails (78, 79) over the
brackets on the Uprights. Be careful not to
pinch any wires. Insert the excess wire into the
Right Upright.
Start four 5/16" x 3/4" Patch Bolts (5) with four
5/16" Star Washers (9) into the Uprights (82,
83). Then, start two 5/16" x 1 1/2" Patch Bolts
(4) into the Uprights. Do not tighten the Patch
Bolts yet.
10
5
79
4
77
77
82
4
9
9
5
78
Console
Assembly
83
Bracket
Bracket