Filter
Top Products
Page
MOTOR ERROR 1
PLEASE STEP ADJUST
4 INITIALIZATION
Initialization must be performed before operation and after replacing the
game PC board, Rom or Step Controls. If initialization is not performed, the
game will not function correctly. During initialization, ensure that the step
edges are level.
4-1 Adjustment Method (a)
1. When the power is turned ON the step-lock motor is automatically
checked. The motor check first locks the steps, frees them, then locks
them again.
Note: Ensure that the test switch is OFF during motor check. Also ensure
that the steps are not touched during the motor check, or the check will
not be performed correctly.
2. If the first lock is not completed within
fifteen seconds from power up, an error
display screen appears.
If this happens, refer to section 4-2
“Adjustment Method (b)”, and initialize the
controls. If the error display screen is still
showing after the controls have been
initialized, refer to section 4-3, “Handling
Motor Errors”.
After the motor check is successful the
attract screen is displayed.
3. To initialize the controls, Switch the test switch ON while pressing the
service button.
The screen displays the “SWITCH TEST” screen with INITIALIZE COM-
PETED flashing, Initialization is completed.
4. Turn the test switch OFF to return to normal game mode.
SWITCH TEST
TEST SW ON
COIN SW ON
SERVICE SW ON
R SELECTION BUTTON On
DECISION BUTTON ON
L SELECTION BUTTON ON
SWING 0000 0000 CENTER
EDGE 0000 0000 CENTER
INITIALIZE COMPLETED
L/R SELECT + DECISION : EXIT
18