Filter
Top Products
Page
2. INSTALLATION
Notes on Installation
DANGER: NEVER turn the power to the machine ON until installation has
been completed.
DANGER: In order to avoid injury or damage to the machine due to mis-
operation, ensure that the voltage of the mains is 220-240volt AC.
Also, in order to prevent possible electric shocks, be sure that the
machine is connected to the mains supply with a securely
connected earthed plug.
NOTE:
So that customers are not injured by the movement of the Ski Tray,
ensure that there is at least 300mm separation between other
machines or walls.
If two Alpine Racer machines are next to each other the space
between them must be at least 600mm.
NOTE:
In order to gain access to the Power Supply and CPU assemblies,
make sure that the rear of the machine is separated from a wall or
other machine by at least 500mm.
WARNING If the location site of this machine has a polished floor it is recom-
mended that rubber pads are fitted under the level adjusters to pre-
vent the machine sliding on the floor.
2