Filter
Top Products
30 MOMENTUM T7 TREADMILL
COMPUTER OPERATION
CUSTOM SAVE:
The program can allow one custom programs to be set by users and store the settings for repeated workouts. The maximum
workout time of each user program is 60 minutes. During the workout after the TIME counts up to 60:00, the treadmill will start a
one-minute cool down procedure automatically. To set and store the user programs, please f ollow the procedure below:
SET AND SAVE THE USER PROGRAM
When the treadmill is in PROGRAM SELECT status, press the
button. The screen will display C1. Press button again to
Select between C1 to C3 and press the STOP/ENTER button to enter the user program then press the START button. Speed
starts at 3.2 km/h / 2.0 mph and the incline level starts at level 0. Each section of SPEED/INCLINE is one minute. Press the
SPEED UP/DOWN buttons to change the speed and press the INCLINE UP/DOWN buttons to change the incline during the
workout. The computer will take the actual speed and incline level at the last second of each minute section and temporary save
as the speed and incline level of that minute section. Continue the workout until you want to stop. Press the STOP button to enter
the one-minute cool down session. The computer will automatically enter the sav e program status after the one-minute cool down
session. If you want to skip the cool down procedure, press the STOP button to enter the save program status.
When the computer is in save program status, the “CUSTOM SAVE” button will blink slowly. Press the ENTER button to sav e this
program or press the STOP button to delete the program and return to POWER ON status.
EDIT PREVIOUS SAVED PROGRAM
Edit the Speed and Incline without extending the previously saved workout time:
Simply press the SPEED UP/DOWN and INCLINE UP/DOWN buttons to change the speed and incline lev el during the workout
then follow the SET AND SAVE procedure after completing the workout.
Extend the workout time from the previously saved program:
If you want to extend the total workout time from the previously saved program press the START button anytime during the
workout. The LED of the CUSTOM SAVE button will light up and blink for 10 seconds then stay lit up. After completing the
previously saved program the treadmill will start a one-minute cool down session. Press the START button again during the cool
down session and the treadmill will skip the cool down procedure and continue running at a speed of 3.2 km/h / 2.0 mph and incline
of level 0. Press the SPEED UP/DOWN and INCLINE UP/DOWN buttons for every minute section then follow the SET AND SAVE
procedure after completing the workout.
If you already press the START button once during the workout and intend to extend the workout time but decide not to extend the
workout time, press the START button again to switch off the LED light of CUSTOM SAVE button. Or wait till the previous saved
program complete and complete the cool down procedure then follow the SET AND SAVE procedure.
HEART RATE CONTROL:
When the treadmill is in PROGRAM SELECT status, press the
button.
TIME SET UP – After selecting the HEART RATE CONTROL program, the TIME LED will show a blinking pre-set workout time of
60:00. Press the SPEED UP/DOWN button to adjust the workout time then press the ENTER button to confirm. Press the START
button to start the program. During the program please make sure to wear the chest belt or hold the hand pulse contact sensor on
the handle bar at all times. Exercising without chest belt or failure to hold the contact sensor will cause the program f ail and
discontinue.