Filter
Top Products
The LifeCORE Sport Trainer comes with this optional handlebar post STABILITY PLUG [108].
This STABILITY PLUG [108] can not be assembled by the manufacturer as it would increase the
carton size and reduce the container loading which inturn would increase the cost. So in order to keep
costs down to our valued customers and still provide the STABILITY PLUG [108] these optional
assembly instructions where devised.
The STABILITY PLUG [108] will help stabilize the HANDLEBAR POST [007]. If you feel that the
HANDLEBAR POST [007] is already stable enough then you need not bother with this optional
assembly. However if when the HANDLEBAR POST [007] is set at maximum and you can feel the
HANDLEBAR POST [007] wobble slightly then this optional assembly will eliminate the wobble.
With the LifeCORE Sport Trainer fully assembled, lower the HANDLEBAR POST [007] to level 1,
the lowest level and do not tighten KNOB [105].
Insert the STABILITY PLUG [108] with the tabs pointing to the rear of the machine as illustrated in
the diagram below, into the bottom of the HANDLEBAR POST [007].
Ensure the STABILITY PLUG [108] is completely inserted into the HANDLEBAR POST [007] as
a)
b)
c)
TAB
STABILITY PLUG [108]
007
105
108
OPTIONAL ASSEMBLY INSTRUCTIONS
6
shown in the picture below.