Filter
Top Products
SPEED TRANSMITTER
Note that there is no wire connected to the computer. This allows for more
freedom with handlebar adjustment and improves the appearance of the bike.
However this also means that the speed signal is sent to the computer via a radio
wave by the speed transmitter which runs on a battery. This battery needs
replacing after approximately six months of home use.
The speed transmitter must be pointing towards the computer as shown in the
diagram in order for the computer to receive the speed signal.
The speed transmitter has a red LED that will flash once every revolution of the
flywheel. If the red LED does not flash then replace the battery. If that fails to
correct the problem then contact your dealer for a replacement.
BATTERIES
BATTERY INSTALLATION ~ SPEED TRANSMITTER: The speed transmitter is
visibly located at the front of the bike. Remove the battery cover and install one
piece of CR2032 3V battery. Replace the battery cover and insure it is tightly closed.
RED
LED
SPEED
TRANSMITTER
BATTERY INSTALLATION ~ COMPUTER: Remove the battery cover at the rear of the computer and install
two pieces of SIZE"AA" 1.5V batteries. Insure the batteries are correctly positioned and the battery springs
are in proper contact with batteries. Replace the battery cover and insure it is tightly closed.
BATTERY LIFE: Battery life is approximately six months of home use, depending on frequency of use and the
quality of the batteries. To ensure long battery life we suggest using alkaline or lithium batteries.
COMPUTER LOW BATTERY Display: The low battery display will flash when the computer batteries
need replacing.
SPEED TRANSMITTER LOW BATTERY: When the computer speed display is irregular or not
responding then it is time to replace the speed transmitter battery.
Auto Power Up & Power Down
AUTO POWER UP: The computer will automatically power up when the bike is in use. Note, there is a brief
delay. The computer will also power up when any keys are pressed.
AUTO POWER DOWN: The computer will automatically power down when the bike is not in use after
approximately 75 seconds.
()
TIME or DISTANCE
TARGET VALUES
TIME or DISTANCE target values are optional. You can only choose one target value, either time or distance. If
you do not select any of these optional target values then the computer will count from zero upwards. If you
select one of these optional target values then the computer will countdown from your selection. The computer
will stop and sound an alarm once the target value has been achieved. Press the SELECT Key to stop the alarm.
TIME: 1:00~99:55:00 minutes (in 5 minute steps).
DISTANCE: 1.0~999.0 kilometers or miles (in 1.0 steps).
HEART RATE RECEIVER and CHEST BANDS
The computer has a built in chest band receiver that uses the international standard 5 kHz bandwidth. Your heart
rate will only register on the computer if you are wearing a compatible chest band. If you are unsure that your
existing chest band is compatible then contact your dealer for verification.
TROUBLE SHOOTING SOLUTIONS
If for any reason you are having trouble with your computer or speed transmitter then try the following suggestions:
1) SPEED TRANSMITTER FUNCTION: With someone pedaling the bike, check to ensure that the speed
transmitters red LED is flashing as shown in the diagram above. If not flashing then replace the battery.
2) SPEED TRANSMITTER DIRECTION: Check to ensure that the speed transmitter is pointing towards the
computer as shown in the diagram above.
3) COMPUTER RESET: Press and hold the SELECT Key for three seconds.
4) COMPUTER REBOOT: Disconnect the power for approximately 15 seconds by removing the batteries.
Wait 15 seconds, then reinstall batteries.
5) REPLACE BATTERIES: Discard the old computer and speed transmitter batteries and replace them with
fresh new alkaline or lithium batteries.
COMPUTER
14
COMPUTER INSTRUCTIONS