Filter
Top Products
6
1.4 SETUP
Tools required: Socket set, Phillips Screwdriver, 9/16 open end wrench
Please read instructions carefully before assembly. Be sure to assemble the unit where it is to be used.
STEP 1
Remove the machine from packaging. Carefully lay out and count each part before
assembly. Refer to the parts list on page 5 of this manual.
STEP 2
Assemble the upright tube assembly to the base frame:
NOTE: This step could require two people.
1. Lay the upright tube assembly (A) on floor in front of base frame (B).
2. Connect the upper wire harness (C) to the lower wire harness (D). Insert connected plugs of the wire harnesses into wiring
hole on upright tube assembly (A).
3. Position the upright tube assembly (A) between the plates on the front of the base frame (B). Feed any excess wire harness
into the base frame.
4. Line up the holes on the plates with the holes on the upright tube assembly (A).
5. Connect the upright tube assembly (A) to the base frame (B) using four (#5) 2-3/4 bolts, eight (#9) washers (4 on each
side) and four (#7) low profile nylock nuts. DO NOT FULLY TIGHTEN AT THIS POINT.
CAUTION: The wire harness may obstruct the connecting holes. If this happens, gently pull on the end of the wire harness at
the top of the upright tube assembly (A) to clear the hole. Do not force the bolt through the hole if the wire harness is
obstructing the bolt, as damage to the wire harness my result.