Filter
Top Products
4.4 TROUBLESHOOTING THE
EXERCISE BIKE
Problem Solution
I hear a clicking noise while I'm pedaling. Use the wrench that was included with the bike to ensure the pedals
are assembled as tight as possible.
My console does not turn on (light up). Check to make sure the power supply cord is fully plugged into the rear
of product and into the wall.
My console has strange characters on the Unplug the bike from the wall or rear of the plastic shrouding and then
display or my console seems like it is frozen. plug the bike back in to reset the console.
The seat wobbles on my recumbent bike. The seat carriage can be adjusted if it is too tight and does not slide
freely or if it is too loose and rocks excessively.
To adjust the fit of the carriage when there is excessive rocking use a
wrench to loosen the jam nut on either side of the seat carriage. With
another wrench, tighten the adjustment roller on the inside of the
carriage until is it snug, but do not over-tighten. Then, while holding the
roller in place, tighten the lock nut. Repeat the procedure for the other
side of the carriage.
To adjust the fit of the carriage when it does not slide freely, use a
wrench to loosen the jam nut on either side of the seat carriage. With
another wrench, loosen the adjustment roller on the inside of the
carriage until it can move freely, but do not excessively loosen. Then,
while holding the roller in place, tighten the lock nut. Repeat the
procedure for the other side of the seat carriage.
31