Filter
Top Products
Page 11
Secure the transmitter to the bike with two M4 x 40 4.
screws; tighten with a 3 mm hex key.
Reinstall the transmitter battery cover and screw; 5.
tighten with a 2.5 mm hex key.
Checking the Installation:
Turn the console on by pressing START.1.
Rotate the cranks for 10 seconds and verify that the 2.
console is picking up the crank rotation and displaying
RPM’s in the cadence section of the display window.
If you do not see RPMs in the display window, press 3.
the [CADENCE] key repeatedly until “INST” RPM
is shown in the display window. If RPM still does
not show, refer to the troubleshooting section of this
manual.
INSTALLATION OF PILOT