Filter
Top Products
STEP 35:
FIGURE 35
25
• Adjustments can be made in the above locations to set the correct amount of tension in the cables.
• If upon completion of assembly, the HEAD PLATE (29) does not sit on top of the first WEIGHT PLATE (31), push the HEAD
PLATE (29) down, insert the WEIGHT STACK PIN (33) and perform several repetitions. This will relax the cable system and
prevent the HEAD PLATE (29) from lifting up. See FIGURE 35.
• For maximum performance, the HEAD PLATE (29) should just barely sit on the top WEIGHT PLATE (31).
• SECURELY assemble the LEFT and RIGHT SHROUDS (23 & 24) to the STACK BOOM (8) and BOTTOM SHROUD
BRACKET (20) using eight 3/8 X 1” BUTTON HEAD BOLTS (71) and eight 3/8” BLACK SAE WASHERS (74) as shown in
FIGURE 35.
74
24
23
71 3/8 X 1” (25m)
BUTTON HEAD
20
8
SERIAL #
LOCATION