Filter
Top Products
16
STEP 20:
FIGURE 20
• Insert one 5-1/2” TAPPED PIVOT SHAFT (41) into the PIVOT ARM (9).
• SECURELY assemble the PRESS ADJUST PLATE (26) to the PIVOT ARM (9) using three BLACK RH CAPS (77),three RH
CAPS (78), two 3/8 X 2-1/2” BOLTS (64), one 3/8 X 3-1/2” BOLT (63), six 3/8” SAE WASHERS (75), six 3/8” RH WASHERS
(76) and three 3/8” LOW HEIGHT LOCK NUTS (73) as shown in FIGURE 20.
3/8 X 2-1/2”
(67m) 64
76
75
73
77 BLACK
41
9
26
78
STEP 21:
FIGURE 21
16
75
3/8 X 1-3/4”
(43m) W/NYLOCK 52
60 3/8 X 1” (25m)
10
9
76
• SECURELY assemble the COUNTERBALANCE (16) to the PIVOT ARM (9) using two RH CAPS (78),two BLACK RH CAPS
(77), two 3/8 X 1” BOLTS (60), four 3/8” SAE WASHERS (75), four 3/8” RH WASHERS (76) and two 3/8” LOW HEIGHT LOCK
NUTS (73) as shown in FIGURE 21.
• SECURELY assemble the PRESS ARM (10) to the PIVOT ARM (9) using two RH CAPS (78), two 3/8 X 1-3/4” BOLTS W/
NYLOCK (52), two 3/8” SAE WASHERS (75) and two 3/8” RH WASHERS (76) as shown in FIGURE 21.
BLACK 77
78
63 3/8 X 3-1/2” (90m)
BLACK
77
78
73
78