Filter
Top Products
STEP 13:
A. Securely assemble the ball end of the Leg Cable (30) and one 3-1/2" Pulley (37) to the Leg
Pedestal (8), using two 3/8 x 3-3/4" Bolts (57), two 3/8 x 1-1/16" Flange Spacers (49), two 3/8"
Flat Washers (64) and two 3/8" Lock Nuts (63).
Note: The Leg Cable (30) must be routed over the retaining bolt as shown in Figure 13.
B. Securely assemble one 3-1/2" Pulley (37) to the Front Base (1), using one 3/8 x 3" Bolt (67), two
3/8 x 3/4" Flange Spacers (49), two 3/8" Flat Washers (64) and one 3/8" Lock Nut (63).
Note: The Leg Cable (30) must be routed over the retaining bolt as shown in Figure 13.
C. Carefully slide the Guide Cables (65) through the Guide Bracket (43) as shown in Figure 13(B).
D. Reassemble the ends of the Guide Cables as shown in Figure 13(B)by attaching the Short
Cables and Turnbuckles that were removed in Step 11(D).
E. Assemble one 3-1/2" Pulley (37) to the Base Plates (11), using one 3/8 x 4-1/4" Bolt (68), two 3/8"
Flat Washers (64), two Guide Cables (65), two 3/8 x 1" Spacers (51) and one 3/8" Lock Nut (63).
Note: Loop the Leg Cable (30) around the 3-1/2" Pulley (37) before attaching it to the Base
Plates (11), as shown in Figure 13.
F. Adjust the Turnbuckle on each Guide Cable (65) to add tension to the Guide Cables (65) until
they are taut. Secure Turnbuckle with the Jam Nuts as seen in Figure 13(B).
21
3/8 X 3-3/4” 57
8
11
51
63
30
37
64
49
48
3/8 X 4-1/4” 68
3/8 X 3”
64
63
2
67
42
SHORTCABLE
65
(B)
TURN BUCKLE
FIGURE 13