Filter
Top Products
STEP 11:
A. Loop the Weight Stack Cable (29) around one 3-1/2" Pulley (37).
B. Assemble the 3-1/2" Pulley (37) with the Weight Stack Cable (29) around it to the Boom Plates
(14 & 15) using one 3/8 x 4-1/4" Bolt (68), two 3/8" Flat Washers (64), two Guide Cables (65),
two 3/8 x 1" Spacers (51) and one 3/8" Lock Nut (63). See Figure 11.
C. Screw the short threaded end of the Weight Stack Cable (29) into the end of the Guide Bracket
(42). See Figure 11.
D. Disassemble the Short Cables and the Turnbuckles on the ends of the Guide Cables (65) as
shown in Figure 11. Set these pieces aside; the Guide Cables will be reassembled later.
19
FIGURE 11