Filter
Top Products
15. Locate the LEFT ACCESSORY TRAY (11). Carefully slide the tray into
the top of the L
EFT UPRIGHT (1) as shown until fully seated.
Secure the accessory tray to the LEFT TOP MOUNTING PLATE (H)
using four SCREWS (21). Repeat the procedure for the RIGHT
ACCESSORY TRAY (12) and RIGHT TOP MOUNTING PLATE (J).
16. Tighten all UPRIGHT BOLTS securely.
17. Replace the M
OTOR COVER (E) and secure the MOTOR COVER
to the FRAME (C) using the four previously removed SCREWS
(D). Tighten the SCREWS securely. Do not overtighten the SCREWS.
18. Replace the F
RONT GRILL (B) and secure the FRONT GRILL to the
FRAME (C) using the four previously removed SCREWS (A).
Tighten the SCREWS securely. Do not overtighten the SCREWS.
19. Locate one S
CREW GROMMET (18). Insert the SCREW GROMMET
into the square hole located above the top inside mounting bolt
of the RIGHT UPRIGHT (2). Repeat for the remaining SCREW
GROMMET and LEFT UPRIGHT (1).
20. Locate one LOWER UPRIGHT COVER (10). Position the LOWER
UPRIGHT COVER at the bottom notch of the RIGHT UPRIGHT (2)
making sure the top lip of the UPRIGHT COVER is engaged under
the outside notch of the RIGHT UPRIGHT. Secure the UPRIGHT
COVER to the RIGHT UPRIGHT using one SCREW (16). Tighten the
S
CREW securely. Do not overtighten the SCREW. Repeat the pro-
cedure for the LEFT UPRIGHT (1) and remaining UPRIGHT COVER.
21. Locate the U
PRIGHT PLUGS (25). Insert one UPRIGHT PLUG into
each of the two access holes located on the lower outside of the
LEFT and RIGHT UPRIGHTS (1 & 2).
22. Locate and press the H
ANDLEBAR CAPS (13) over the ends of the
HANDLEBARS (3). Be sure the HANDLEBAR CAPS are fully seated.
23. Using two SCREWS (16) each, attach the two REAR FRAME END
CAPS (14) to the FRAME (C) as shown. Tighten the SCREWS
securely. Do not overtighten the SCREWS.
24. The treadmill striding belt must be “walked-in” for five
minutes after assembly is complete.
Plug the treadmill into an appropriate outlet. Turn the treadmill
on at the on/off switch. Select QUICK START from the console.
Increase the speed to 3 mph (4.8 km/h). Start walking in the
front left corner of the walking surface and drift to the back,
move to the center of the deck and walk towards the front, and
finally walking to the right corner and drifting to the back.
Continue pattern for five minutes.
25. Refer to the specific treadmill’s Operation Manual for power
requirements, proper line cord routing, and other critical product
information before connecting the treadmill to a power source.
3
13
C
14
14
16
7
2
16
10
18
25
1
2
12
11
21