Filter
Top Products
6.5 TROUBLESHOOTING THE EXERCISE BIKE
Problem Solution
I hear a clicking noise while I'm pedaling. Use the wrench that was included with the bike to ensure the pedals
are assembled as tight as possible.
My console does not turn on (light up). Make sure that you are pedaling at a fast enough pace (25-30 RPM) to
power the console. The console should automatically light up. If the
console does not light up when pedaling, remove the console and make
certain that the console wiring is fully connected and is not damaged.
My console has strange characters on the Stop pedaling and wait 15 minutes for the console to reset.
display or my console seems like it is frozen.
The seat wobbles on my recumbent bike. The seat carriage can be adjusted if it is too tight and does not slide
freely or if it is too loose and rocks excessively.
To adjust the fit of the carriage when there is excessive rocking use a
wrench to loosen the jam nut on either side of the seat carriage. With
another wrench, tighten the adjustment roller on the inside of the
carriage until is it snug, but do not over-tighten. Then, while holding the
roller in place, tighten the lock nut. Repeat the procedure for the other
side of the carriage.
To adjust the fit of the carriage when it does not slide freely, use a
wrench to loosen the jam nut on either side of the seat carriage. With
another wrench, loosen the adjustment roller on the inside of the
carriage until it can move freely, but do not excessively loosen. Then,
while holding the roller in place, tighten the lock nut. Repeat the
procedure for the other side of the seat carriage.
38