Filter
Top Products
7
Assembly
Figure 3: Right Upright Installation
2. Locate the tight upright. Connect the
console harness together. One side of har-
ness is located near the motor cover on
the bottom right side. The other end is
located inside the right upright.
Connect the amplifier harness together.
One side of harness is located near the
motor cover on the bottom right side.
The other end is located inside the right
upright.
Slide the left upright onto the base frame.
Secure the left upright to the base frame
by using four bolts M10x25 and four wash-
ers #10.
Bolt M10x25
Washer #10
Amplier
Harness
Figure 4: Crossbar Installation
4. Locate the cross bar. Slide the cross
bar in between the left and right uprights.
Secure the cross bar using one washer #8
and one bolt M8x52 on the right side and
one washer #8 and one bolt M8x26 on the
left side.
Crossbar
Washer #8
Bolt M8x52
Note: Make sure that the console harness
and the amplier harness are inside of the
upright and not being pinched.
Console
Harness
Bolt M8x26