Filter
Top Products
STEP 5 (See Diagram 5 & Cable Loop Diagram)
A.) Attach the 118” Upper Cable (#59) to the opening on the front of the Upper
Frame (#4). Note: The Ball Stopper on the cable should be underneath the
Frame.
B.) Attach a Pulley (#62) to the opening. Secure it with one M10 x 2 ½” Allen Bolt
(#69), two Ø 7/8” x 5/8” Pulley Bushings (#44), and one M10 Aircraft Nut (#83).
C.) Draw the Cable over the Pulley towards the back of the machine to the second
opening on the Upper Frame. Repeat step B above to install a Pulley.
D.) Draw the Cable around the Pulley then pull back to the opening on the Front
Press Base (#6).
E.) Attach a Pulley to the opening on the Front Press Base. Secure the Pulley with
one M10 x 6 ¾” Allen Bolt (#97), two Ø ¾” Washers (#84), and one M10 Aircraft
Nut (#83).
F.) Draw the Cable around the Pulley and then to the opening on the Front Vertical
Frame (#3). Attach a Pulley to the opening. Secure it with one M10 x 2 3/8” Allen
Bolt (#70), two Ø 7/8” x ½” Pulley Bushings (#45), and one M10 Aircraft Nut
(#83).
G.) Draw the Cable around the Pulley then pull the Cable downwards. Attach the
Cable to two Double Floating Pulley Brackets (#23). Attach a Pulley and a L-
shaped Cable Retainer (#27) to the top holes on the Brackets. Secure them with
one M10 x 1 ¾” Allen Bolts (#71), two Ø ¾” Washers (#84), and one M10 Aircraft
Nut (#83). Let the Brackets hanging just for now.
H.) Pull the Cable upward to the opening on the rear of Upper Frame. Repeat B to
install a Pulley.
I.) Pull the Cable downward between the two Guide Rods to the Selector Rod (#14).
Thread the bolt at the end of the Cable into the opening on top of the Selector
Rod to secure the Cable.
J.) Connect a Chain (#66) to the Cable with a Hook (#67). Connect the Lat Bar to
the Chain with another Hook. Change the length of the Chain to the Cable to
obtain the desired Lat Bar exercises.
15