Filter
Top Products
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches
NOTE: It is strongly recommended two or people assembling this machine to avoid
possible injury.
STEP 1 (See Diagram 1)
A.) Place the Right Base Frame (#31) on a flat surface. Make sure there is enough space
around to assemble the machine.
B.) Insert four Guide Rods (#16) into the holes on the Right Base Frame. Secure each
Guide Rod from bottom with a M10 x ¾” Allen Bolt (#95) and Ø ¾” Washer (#100).
C.) Attach four Ø 2 3/8” x 1” Rubber Bumpers (#52) to top of the Guide Rods then slid down
to the stopper on the Guide Rods.
D.) Attach the Right Vertical Frame (#4) onto the Right Base Frame. Secure it with two M10
x 2 ¾” Carriage Bolts (#98), one 4 ¾” x 2 ¾” Bracket (#25), two Ø ¾” Washers (#100),
and two M10 Aircraft Nuts (#102).
E.) Attach the Butterfly Base (#13) to the Right Base Frame (#31). Attach the Front Base
Frame (#12) to the Butterfly Base (#13) from the front. Align the holes and secure them
together with two M10 x 3 ¾” Carriage Bolts (#97) from side, two M10 x 2 ¾” Carriage
Bolts (#98) from the bottom, four Ø ¾” Washers (#100), and four M10 Aircraft Nuts
(#102).
F.) Slide fourteen Weight Plates (#80) onto the rear set of Guide Rods. Make sure the
groove on the plates all face toward the back of the machine.
G.) Insert a Selector Rod (#28) into the center holes. Slide a Selector Stem (#81) onto the
two Guide Rods.
H.) Insert a Weight Selector Pin (#74) to select the number of weight plates. Each Weight
Plate weights approximately 10 lbs. Please refer to the Weight Resistance Chart in page
35.
I.) Repeat procedures F, G and H above to install the other fourteen Weight Plates onto the
front two Guide Rods.
J.) Attach the Foot Plate (#17) to the Front Base Frame (#12). Secure it with the Foot Plate
Axle (#18).
7